The TNC NC-230 is intended for control of the two-support rigs, treating milling and turning centres. The included principle of compactness has made possible deriving in the device of high dependability, noninterference, and a low power drain.

Complectation and main characteristics:

• Monitor: 10,4"
• Correctors turn knobs: F%, S%, MODE
• Hermetic button keyboard
• Buttons: "START", "STOP"
• Emergency stop (mushroom) button
• Functional keyboard for bench board realization
• The standard milling- and turning oriented software
• DAC: 6 channels
• Feedback transmitters: 5 channels
• Galvanic isolated outputs 48-96 channels
• Galvanic isolated inputs 64-128 channels
• Channels: FDD, RS-232, Ethernet, USB
• Network support LAN (Ethernet)
• USB flash drive: 128 Mb
• Cables FDD, USB-FLASH
• CNC emulator software for PC
• Size: 439x340x140

Output relais module with indication (NC-210-401).

• Outputs - 24 DC 24V/3A, AC 110V/3A
• LEDs - 24
• Mounted on DIN rail
• Size 270x83x30

Input module with indication (NC-201-402).

• Inputs - 40
• LEDs - 40
• Mounted on DIN rail
• Size 127x83x40

The portable control board (NC-310-78).

• The 5-positions turn knob
• The 5-positions turn knob
• Buttons - 3 pcs.
• The additional side button - 2 pcs.
• Emergency stop (mushroom) button
• Size 153x75,6x80

Handwheel (NC-110-75).

• Impulses on turn - 100
• Power supply - +5V
• Diameter - 80 mm

Handwheel (NC-310-75).

• Impulses on turn - 100
  
• Power supply - +5V
  
• Diameter - 60 mm